Circuit Splash

In this project we are going to design a 25V range digital voltmeter by using ATMEGA32A microcontroller. In ATMEGA, we are going to use 10bit ADC (Analog to Digital Converter) to build a digital voltmeter. Now the ADC in ATMEGA can not take a input more than +5V, so for getting a higher range we are going to use a voltage divider circuit.

The MCP3008 is an 8-Channel 10-bit ADC IC, so it can measure 8 different analog voltage with a resolution of 10-bit. It measures the value of analog voltage from 0-1023 and sends the value to a microcontroller or microprocessor through SPI communication.

The Schmitt-trigger is a circuit which creates hystereses and which is useful in digitizing an analog signal into a digital signal of either high or low. The hystereses makes inputs more immune to noise. The input must surpass a low threshold voltage before the output goes low, and likewise the input must exceed a high level threshold before the output goes high.

A potential divider circuit is a very common circuit used in electronics where an input voltage has to be converted to another voltage less than it. This circuit is very useful for all analog circuits where variable voltages are required, hence it is important to understand how this circuit works and how to calculate the values of Resistors.

In this project we are going to make Clapper circuit using the concept of ADC (Analog to Digital Conversion) in ARDUINO UNO. We are going to use a MIC and Uno to sense the sound and trigger a response. This Clap ON Clap OFF switch basically turns ON or OFF the device, by using the clap sound, as switch

We can divide this arduino based thermometer project into three sections - one senses the temperature by using temperature sensor LM 35, second section converts the temperature value into a suitable numbers in Celsius scale which is done by Arduino, and last part of system displays temperature on LCD.

In this DIY project we make a Digital clock by multiplexing four- 7 segment displays using Arduino UNO and displaying the time in HH:MM format. This tutorial covers all the DIY instructions, circuit diagram and required code.

LED interfacing is the first thing, one would try to do while getting started with any microcontroller. So here in this tutorial we are going to interface a LED with 8051 microcontroller, and will write a C Program to blink the LED. We have used a very popular microcontroller AT89S52, of 8051 family, by ATMEL.

We all are familiar with dice and often played LUDO or SANP SIDI (Snake & Ladders) game by using dice. Dice is a squire type solid box which contains 6 different numbers on all of its sides. We throw dice on a surface to get a random number while playing the games. In this project we have tried to replicate it with a digital dice using arduino uno board.